Table of Contents
Advertisement
Option Settings
Setting 14-3: PBX ID NO.
If you set Option Setting 14-2 to 3 (PBX ID digit mode), use this setting to
enter your PBX ID number (maximum of 3 digits). Press the
START/MEMORY key when finished.
Initial Setting: 0
(Note: The ID number is automatically dialled for access to the public line when
Rapid Key or Speed Dialling is used. Do not store it as part of the number when
storing a Rapid Key or Speed Dialling number.)
Setting 14-4: REGISTER RECALL
This sets the recall mode used for special functions of some PTT's (e.g.
Germany, Sweden), as well as transferring calls on a PBX. Refer to your PBX
manual or consult your supplier for the correct setting. Make the selection by
entering a number from 1 to 3 as follows:
1:
2:
3:
Initial setting: 2
Setting 15: FAX SIGNAL RECEIVE
Your fax will automatically begin reception if you hear a high-pitched fax tone
after answering a call. If you use a computer fax modem on the same line, you
must turn this function off in order to prevent your fax from mistakenly
attempting to receive documents sent from the computer fax modem. Press 1 to
turn the function on, or 2 to turn it off.
Initial setting: 1
FUNCTION
YES
1
90
Earth
Flash
No operation
Press
4
NO
JUNK FAX # CHECK
or
2
until
FAX SIGNAL RX
display
shows:
STOP
Advertisement
Table of Contents
