Copier Installation - Sharp AR-156 Operation Manual

COPIER INSTALLATION

Improper installation may damage the copier. Please note the following during initial installation
and whenever the copier is moved.
If the copier is moved from a cool place to a warm place, condensation may
form inside the copier. Operation in this condition will cause poor copy quality
1
and malfunctions. Leave the copier at room temperature for at least 2 hours
before use.
Do not install your copier in areas that are:
G
damp, humid, or very dusty
G
exposed to direct sunlight
G
poorly ventilated
G
subject to extreme temperature or humidity
changes, e.g., near an air conditioner or
heater.
The copier should be installed near an accessible power outlet
for easy connection.
Be sure to connect the power cord only to a power outlet that
meets the specified voltage and current requirements.
Also make certain the outlet is properly grounded.
Connect the copier to a power outlet which is not
used for other electric appliances. If a lighting fixture
is connected to the same outlet, the light may flicker.
8
00C-1-156ex.p65 8 4/11/00, 9:35