Code Searching By Brand Name; Code Identification - Medion Remote Control Manual

CODE SEARCHING BY BRAND NAME

This function makes it possible to search the code by the respective brand
name. Find the names enclosed in the code table. Do as follows:
Switch on the device you want to operate.
1. Press and hold "SETUP" for 3 seconds. The mode LED lights up
continually. (If you press the "SETUP" button only once you activate the
SHIFT- function).
2. Release "SETUP" button.
3. Shortly press the button for the mode you want to operate (TV, VCR,
SAT).
4. Enter the 1-digit-code from the code table. (code searching by brand
name)
5. Press the button "POWER" or "PROG+" or "PLAY" several times until
the device works as desired.
6. Store the code by pressing "OK".
Did you run through all codes the mode LED blinks for about 3 seconds.

CODE IDENTIFICATION

This code identification gives you the possibility to select the stored codes
directly with the remote control.
1. Press and hold "SETUP" for 3 seconds. The mode LED lights up
continually. (If you press the "SETUP" button only once you activate the
SHIFT- function).
2. Release "SETUP" button.
3. Shortly press the button for the mode you want to operate (TV, VCR,
SAT). If the operating modus is accepted the mode LED goes out for
a moment.
4. Shortly press the "SETUP" button. If the operating modus is accepted
the mode LED goes out for an instant.
5. To find the first number press the numbered buttons shortly one after the
other. If the code number is correct the mode LED goes out for a moment.
This is the first stored number. For the second and third number use the
same procedure.
6. The mode LED goes out to indicate after the third number has been found.
7