Setting Up By Code Entry - Medion Remote Control Manual

SETTING UP BY CODE ENTRY

Please find the codes for operating your equipment enclosed in the codelist
Press the "ON" button to switch on the unit.
1 Press and hold "SETUP" for 3 seconds. The mode LED lights up
continually. (If you press the "SETUP" button only once you activate the
SHIFT- function).
2. Release "SETUP" button.
3. Press and release desired Mode button to select the device you want to
operate (TV, VCR, SAT, etc.).
4. Enter 3-digit-code for your brand from the list. The mode LED confirms
each key pressed.
5. If code set-up was successful the mode LED turns off after having
entered the last number. (If the code was incorrect the mode LED will
blink 3 seconds before it goes out.)
6. The direct code entry is complete now.
If the device does not respond correctly, please repeat the setting
up by trying the next code from the code list for your device until
the equipment works properly.
If none of the listed codes work, go to Chapter SETTING UP BY
MANUAL SEARCH.
4