Table of Contents
Advertisement
5.
When you are finished drilling, turn the compressor off, then remove the
hose connection to the Air Drill.
1.
After each use, wipe the Air Drill with a clean cloth to remove any dirt and
grease buildup.
2.
To maintain tool life, always lubricate the air line by adding a few drops of
pneumatic tool oil to the air line before each use. Or, install the automatic
oiler-filter system as illustrated on page 5.
3.
Before each use, drain water out of the air compressor tank and
condensation from the air lines. Refer to the Air Compressor Operator's
Manual.
Manual Tool Lubrication
1.
Disconnect the Air Drill from the air supply and turn it so the Air Inlet fitting is
facing upward.
2.
Hold the Trigger (8) in and place a few drops of pneumatic tool oil into the
air inlet (use SAE #10 weight oil if air tool oil is not available). Holding the
Trigger lever in helps circulate the oil in the air motor.
3.
Connect the Air Drill to the air supply and cover the Muffler Cover (11) with
a towel. Run for a few seconds. Excess oil with be blown out the Muffler
Cover.
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
SKU 07528
Maintenance
PLEASE READ THE FOLLOWING CAREFULLY
Page 6
Advertisement
Table of Contents
