Table of Contents
Advertisement
uSER-mAIntEnAncE
InStRuctIOnS
Procedures not specifically
explained in this manual
must be performed only by a
qualified technician.
FROm AccIDEntAL
OpERAtIOn:
turn off the tool, detach the
air supply, safely discharge
any residual air pressure in
the tool, and release the
throttle and/or turn the switch
to its off position before
performing any inspection,
maintenance, or cleaning
procedures.
tO pREVEnt SERIOuS
InjuRy FROm tOOL
FAILuRE:
Do not use damaged
equipment. If abnormal
noise, vibration, or leaking
air occurs, have the problem
corrected before further use.
tO pREVEnt ExpLOSIOn:
Lubricate the tool only
with specified lubricants.
Lubricate the air inlet
using only pneumatic tool
oil. Lubricate the internal
mechanism using only
white lithium grease. Other
lubricants may damage the
mechanism and may be
highly flammable, causing an
explosion.
SKU 98896
tO pREVEnt
SERIOuS InjuRy
For technical questions, please call 1-800-444-3353.
cleaning, maintenance, and
Lubrication
note: These procedures are in addition to
the regular checks and maintenance
explained as part of the regular
operation of the air-operated tool.
1.
Daily - Air Supply maintenance:
Every day, perform maintenance
on the air supply according to
the component manufacturers'
instructions. The lubricator's oil
level needs to be maintained and
the moisture filter must be regularly
drained. Performing routine
maintenance on the air supply will
allow the tool to operate more safely
and will also reduce wear on the tool.
2.
Weekly - grease Lubrication:
Lubricate the internal mechanism of
the tool, using white lithium grease
through the grease fittings. See
Lubrication Diagram below.
3.
Quarterly (every 3 months) - tool
Disassembly, cleaning, and
Inspection:
Have the internal mechanism
cleaned, inspected, and lubricated by
a qualified technician. If the vanes
need replacement, all vanes should
be replaced as a set.
Page 12
Advertisement
Table of Contents
