LECOASPIRA 712 E3) Liquid suction fitting 1) Main switch E4) Carpet fitting 2) Boiler button – terracotta / parquet floor E5) Cotton cloths function E6) Cloth with velcro 2A) Parquet function indicator light K) 120° steam-suction accessory 3) “Out of water” indicator lamp K1) Steam lance 4) Pressure indicator lamp L) Small coloured 120°...
Page 5
Read these instructions carefully before using the appliance. Dear Customer, We wish to thank you for placing your trust in us and choosing a Polti product. In choosing your Vaporetto Lecoaspira, you were thinking of the hygiene of your home and of the health of your family, because Vaporetto Lecoaspira allows you to clean most surfaces with the pure power that steam provides.
Page 6
• If it is necessary to replace the power supply jects such as embers, ash or other material cable, please refer to the nearest Polti autho- in which combustion is taking place. rised service centre, since the use of a spe- •...
Page 7
This is a preventive against scale build-up ture. and protects the metal walls of the steam Polti declines liability for any damage or ac- generator tank. KALSTOP is available from cident derived from any use of Vaporetto Polti dealers or by mail-order from your Polti Lecoaspira which is not in conformity with Service Centre.
Page 8
(A2). The suction function will start up at the tank. KALSTOP is available from Polti deal- minimum speed and the first stage of the in- ers or by mail-order from your Polti Service dicator lamp set (5) will stop flashing and re- Centre.
Page 9
LECOASPIRA 712 OPERATION WITH STEAM ONLY or with the insert for fitted carpet (E4), wrapped in a parquet cloth with velcro • Press the main switch (1), the first level of the (E6). suction indicators (5) will start to flash. •...
Page 10
LECOASPIRA 712 Use of the suction controls Another fastening button is present on the Simply by pressing the suction button (A4) you steam+vacuuming extension tubes (D). Pro- will be able to start suction. ceed as indicated above for the other accesso- You will be able to select the speed required for ries and release the tubes by sliding the button the type of surface to be treated by keep ing the...
Page 11
The filter can be composition which contains Tea Tree and other purchased from an authorised Polti Assistance natural substances, it prevents bad smells in- centre). side the dirt collection tank and releases a If you wish to continue working, top up the level fresh clean fragrance in the environment.
Page 12
LECOASPIRA 712 doors, etc.) and brick floors always proceed layered coating and paintwork; with caution since excessive use of steam • cleaning corners such as stairs, windows could damage the wax, the polish or the colour frames, door jambs, aluminium sections; of the surface to be cleaned.
Page 13
• apply steam uniformly to the surface to be PFEU0021). You may purchase the iron ac- cleaned to dissolve the soiling. cessory at any Polti service centre or from • Press the rubber squeegee against the sur- top home appliance retailers.
Page 14
“EMPTY- RECOMMENDED TECHNIQUE for STEAM iro- CLEANING DIRT ning with Polti iron is APPLY steam (button X) CONTAINER”. on the upstroke, then release button (X) (so no steam) for the backstroke, so reclosing the fi- bres, preventing oversteaming and wetness.
Page 15
LECOASPIRA 712 • To correctly position the Hepa filter (17) make sure that it fits properly into its recess (19) and then that the release lever closes over it holding it in place (18) (Fig.14). WARNING: • Do not clean the filter with the brush, as this could damage it, decreasing its filtering ca- pacity.
Need help?
Do you have a question about the VAPORETTO LECOASPIRA 712 and is the answer not in the manual?
Questions and answers