Samsung SHR-3010P User Manual page 9

DIGITAL VIDEO RECORDER
GB
Caution
Caution
Please be sure to turn the system off before you replace or add the HDD. If not,
the HDD may poorly operate or the life may be reduced.
Mode setup and cable connection
Set a HDD mode and connect cables after mounting the HDD to product.
Below is shown drawing of Power Connector and AT-Bus Interface Connector and
Configuration Jumper Block of HDD.
Setting of HDD mode is performed in a Configuration Jumper Block.
When mounting two hard disk drives on the product, one should be set in the Master Mode
and the other in the Slave Mode. Basically, since the hard disk drive mounted on the product is
in the Master Mode, when mounting a new hard disk drive it can be set in the Slave Mode.
For example, mode is set as follows in case of Samsung Spinpoint V80 HDD:
1-9
AT-Bus Interface Cable and Power Supply Cable are connected to AT-Bus Interface
Connector are connected by referring to following drawing to ensure the HDD mounted on
product can properly operate.
AT-Bus
Interface
Connector
40Pin
AT-Bus
40Pin
Interface
Header
Cable
Power Supply
Cable
(4Pin)
If successfully mounting the HDD on the product and then booting the system, the system
recognizes that a new HDD is mounted and starts to operate after formatting the first HDD.
Caution Caution
Use the HDD installed by default infrom the factory.
Use FUJITSU MAP3367NP, SEAGATE BARRACUDA ST32171W products only for
SCSI HDD for backup.
GB
Bevel
DC Power
Connector
1-10