Advertisement
Read this section carefully for correct maintenance!
1.Surface of the Product
Wipe it well with a soft cloth.
Wiping it with any metal or nylon brush may damage it.
Wipe overflowed part with neutral detergent
and dry it fully.
Alkali detergent may damage the coated face of product.
2.Top Plate of the Product
Dried and attached overflow-substance may be too sticky to be
wiped out. Wipe the product right after using.
If too much contaminated, wipe the product using a dried towel with
a neutral detergent, and then wipe it again using a dried cloth.
If you wipe the top plate with a metal brush, it will be damaged.
3.Burner Part
Clean it wearing gloves.
Clean the flame hole of the burner from time to time. If the
burner is contaminated, tis flame hole is clogged making
incomplete ingition.
Caution
Take off the burner head. Clean the upper circumference of the
burner body and burner head using a harsh brush. Use a drill for
cleaning of the flame holes.
If the flame holes are not drilled or the burner head has become
thinned down due to a long period of use, replace it with new one
and keep it clean all the time.
After cleaning, dry the parts completely or assemble them to their
original positions. If the ignition plug or its ambient part is wet,
electricity is not normally discharged.
The safety device for automatic block of gas should be cleaned
without any hard brush and etc. If any soup is flown over, wipe it out
immediately. Otherwise, the product performance will decline and its
life will be reduced as well.
Maintain and clean the product wearing gloves.
Usable
Unusable
Nylon Brush Metal Brush
Soft Cloth
Sponge Brush
Edible Oil
Acidic/Alkali
Detergent
Neutral
Thinner/Benzene
Abrasive
Detergent
Advertisement
