Pacific hydrostar 95591 - .75 HP Set Up And Operating Instructions Manual page 8

When unpacking, check to make sure all the parts shown on the Parts List on
page 12 are included. If any parts are missing or broken, please call Harbor Freight
Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLY And OPERATIng InSTRUCTIOnS
note: For additional information regarding the parts listed in the following pages, refer
to the Assembly diagram on page 13.
WARnIng! Always make sure to turn off the electricity powering the
Pump's electrical outlet and that the Pump is unplugged from its outlet prior to
assembling the unit, unclogging the unit, or making any adjustments to the unit.
1. If necessary, have a certified electrician install (within 10 feet of where the Pump
will be located) a 115 volt, GFCI electrical outlet that is dedicated only to the Pump.
Any outlet should be well above the water line.
2. The discharge has both internal and external NPT threads. Use either 1-1/4" NPT
Male or 1-1/2" NPT Female PVC pipe for the discharge line. Do not use a pipe
smaller than 1-1/4".
SKU 95591/95592/95593
UnPACKIng
For technical questions, please call 1-800-444-3353
REV 08b
PAGE 8