Inspection, Maintenance, And Cleaning - Pacific hydrostar 95591 - .75 HP Set Up And Operating Instructions Manual

Vertical float sump pump

Hide thumbs

Table Of Contents

Table of Contents

Carefully set the Pump in place.

Cord or discharge Pipe. (See Figure E.)

The Float Switch (2) automatically switches on and off at a water depth of approxi-

mately 4 inches. The ON/OFF height can be manually changed by adjusting the

Float Switch Lock. CAUTIOn: Do not run the Pump dry. Doing so will increase

wear to the unit and possibly cause seal damage. (See Figure E.)

note: This Pump has a built-in thermal protector for the Motor which automatically

shuts it off to avoid overheating. After the Motor cools, it will cycle back on. Wait

for the cycle to continue. Do not try to turn on the Pump manually after it has auto-

matically shut off.

Connect additional Discharge Pipe as needed to direct the water discharge to

the desired location. The discharge should be kept as short as possible with a

minimum number of turns. IMPORTAnT: Do not exceed the maximum lift of the

Pump:

Model 95591 = 20 Feet.

Model 95592 = 24 Feet.

Model 95593 = 26 Feet.

Connect the Power Cord & Plug to its 115 volt, GFCI electrical outlet, while making

sure to form a "drip loop" in the Power Cord. (See drip Loop, page 5.)

10.

When the water level exceeds approximately 4 inches the Pump will automatically

turn on and run continuously until the water level falls below 4 inches at which time

the Pump will automatically turn off.

11.

WARnIng! When shutting off power to the Pump, always shut off the electrical

power to the GFCI outlet first. Then, disconnect the Pump's Power Cord & Plug

from the GFCI outlet.