Advertisement
10
TEST INSTALLED FITTING
With HANDLE (1) in OFF position, turn on WATER
SUPPLIES (2) and check all connections for leaks.
Remove AERATOR (3).
Operate both HANDLE (1) to flush water lines thoroughly.
Replace AERATOR (3).
CHECK DRAIN CONNECTIONS
Operate POP-UP KNOB (4) and fill lavatory with water.
Check that DRAIN STOPPER (5) makes a good seal
and retains water in SINK. If DRAIN STOPPER (5)
does not seal properly, please refer to Troubleshooting
section in these instructions.
Release POP-UP KNOB (4) down and check all drain
connections and "P" trap for leaks. Tighten
if necessary.
11
SERVICE
By restricting handle rotation and limiting the amount of hot water allowed to mix with the cold, the HOT LIMIT SAFETY
STOP reduces risk of accidental scalding. To set the maximum hot water temperature of your faucets, all you need to
do is adjust the setting on the HOT LIMIT SAFETY STOP.
Loosen SET SCREW (2) with 2.5mm hex wrench. Pull HANDLE (1) off valve stem.
Pull off CAP (3). Use a flat blade screwdriver or your fingers to pull up and rotate
red HOT LIMIT SAFETY STOP (4). Follow Step "A" or "B" to adjust min./max. discharge
temperature. "0" being the hottest to "7" the coldest temperature setting.
Factory set at "0".
Replace ESCUTCHEON CAP (3),
HANDLE (1), tighten HANDLE
SCREW (2).
"B"
PRY RED RING FORWARD
AND ROTATE CLOCKWISE
"B"
ADJUSTMENT WHEN
WATER IS TOO COLD
12
CARE INSTRUCTIONS:
DO: SIMPLY RINSE THE PRODUCT CLEAN WITH CLEAR WATER. DRY WITH A SOFT COTTON FLANNEL CLOTH.
DO NOT: DO NOT CLEAN THE PRODUCT WITH SOAPS, ACID, POLISH, ABRASIVES, HARSH CLEANERS, OR A
CLOTH WITH A COARSE SURFACE.
PRY RED RING FORWARD
AND ROTATE COUNTER-
"A"
CLOCKWISE ONE CLICK
TEMPERATURE
SETTING NUMBERS
"B"
4
WASTE
OUTLET
2
"A"
"A"
ADJUSTMENT WHEN
WATER IS TOO HOT
4
"RED RING"- HOT
LIMIT SAFETY STOP
4
1
3
5
2
"P" TRAP
1
2
3
M 9 6 8 3 0 5 R E V. 1 . 1
Advertisement
