Using a fully wired 21-pin Scart cable
– You can use a variety of Q Link functions by connecting the unit to a Q Link compatible television (
– You can enjoy high-quality viewing by connecting the unit to an RGB compatible television.
"AV1 Output" in the Setup menu is set to "RGB 1 (without component)" or "RGB 2 (without component)" (
– "AV2 Input" settings in the Setup menu (
Adding a Digital Satellite Receiver: Connecting to a Television and a Digital Satellite
Receiver
To the aerial
Digital satellite antenna
1
The RF coaxial cable cannot be
used for showing pictures from the
unit. The unit must be connected
using another method, e.g. 21-pin
Scart cable to show pictures from
the unit on the television set.
Aerial cable to the "RF IN" on the digital satellite receiver.
RF coaxial cable from the "RF OUT" on the digital satellite receiver to the "RF IN" on the unit.
RF coaxial cable (included) from the "RF OUT" on the unit to the "RF IN/AERIAL" on the TV.
21-pin Scart cable from the "AV/VCR" on the digital satellite receiver to the "AV2 (EXT)" on the
unit.
21-pin Scart cable from the "AV1 (TV)" on the unit to the "AV" on the TV.
21-pin Scart cable from the "AV/TV" on the digital satellite receiver to the "AV" on the TV.
To record digital satellite programmes
Refer to "Recording from a Digital Satellite Receiver" (
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit consumes a small amount of power, even
when it is turned off.
"
[approx. 0.9 W (
Power Save
After completing the above connections, proceed to the TV Tuning (
71)
Digital satellite receiver
HDMI OUT
RF IN
DISH INPUT
AV/TV
RF OUT
AV/VCR
2
RF IN
RF OUT
"
"
"
is set to
On
)]
6
This unit
AV1(TV)
HDMI
4
AV2 (EXT)
AV OUT
3
You can enjoy high-quality picture
by adding the HDMI cable connection 12
29)
Additional Connection
13).
42).
TV
HDMI IN
RF IN/AERIAL
AV
AV
HDMI IN
5
HDMI cable
12, 74
71)
11
RQT9272