Adding A Digital Satellite Receiver: Connecting To A Television And A Digital Satellite Receiver; Connecting Ac Mains Lead (Included) - Panasonic DMR-EZ49VEB Operating Instructions Manual

Adding a Digital Satellite Receiver: Connecting to a Television and a Digital Satellite
Receiver
Digital satellite antenna
6
1 Aerial cable to the "RF IN" on the digital satellite receiver.
2 RF coaxial cable from the "RF OUT" on the digital satellite receiver to the "RF IN" on the unit.
3 RF coaxial cable (included) from the "RF OUT" on the unit to the "RF IN" on the TV.
4 21-pin Scart cable from the "AV/VCR" on the digital satellite receiver to the "AV2 (EXT)" on the unit.
5 21-pin Scart cable from the "AV1 (TV)" on the unit to the "AV" on the TV.
6 21-pin Scart cable from the "AV/TV" on the digital satellite receiver to the "AV" on the TV.
To view digital satellite programmes
Refer to "Watching Digital Satellite Programmes" (
To record digital satellite programmes
Refer to "Recording from a Digital Satellite Receiver" (

Connecting AC mains lead (included)

Connect only after all other connections are complete.
This unit
AC IN
When the unit is not to be used for a long time
To save power, unplug it from the household mains socket. This unit consumes a small amount of power, even
when it is turned off.
[Approx. 0.5 W ("Power Save in Standby" is activated and "RF OUT ( Aerial Signal )" is set to "Off".)]
After completing the above connections, proceed to the TV Tuning (
Digital satellite receiver
DISH
HDMI OUT
INPUT
AV/TV
AV/VCR
4
HDMI
AV OUT
AV2 (EXT) AV1(TV)
5
HDMI IN
AV
HDMI IN AV
19)
To the aerial
1
RF IN
RF OUT
2
This unit
RF IN
RF OUT
TV
3
The RF coaxial cable cannot be
used for showing pictures from the
unit. The unit must be connected
using another method, e.g. 21-pin
Scart cable to show pictures from
the unit on the television set.
RF IN/
AERIAL
HDMI cable
You can enjoy high-quality picture by adding
the HDMI cable connection
31)
To household mains
socket
13).
Additional Connections
12
112, 75
11
VQT2J51