Panasonic Viera TX-L37G15B Operating Instructions Manual page 84

On screen messages
Message
PIN incorrect!
Please check settings and connections
on HDMI devices.
Please enter a frequency between
10700 and 12750 MHz
Please wait.
Recording this channel now
Reset to Factory Shipping Condition
Completed.
Please switch off TV.
Sending Preset Data
Please wait!
Software successfully updated.
Press EXIT to continue.
Software update failed. Please try again
later.
Press EXIT to continue.
This timer will not follow the TV Guide
information
Press OK to continue, RETURN to restore
original timer
Timer already expired !
Timer Event Due to Start
DVB 1: BBC1 has been
programmed for recording at
Timer incorrect !
Timer overlap
Press OK to keep, RETURN to edit
Tuner Locked
Please stop recording to operate
Unable to acquire IP address
Unable to download, please check
equipment
■
SD Card
Cannot read file
No SD card inserted
No valid file to play
Over 9999 pictures found
(max. is 9999)
Please confirm the SD card is OK
This operation is not possible
84
●
The PIN number you entered is wrong.
●
Communication error in VIERA Link function (p. 67).
●
The frequency you entered is out of range. Consult the received satellite
broadcasting company. (p. 42)
●
A function is in progress.
●
The recorder is recording the programme from its own tuner. You can turn
the TV off and leave the equipment recording in the normal way.
●
"Auto Setup" will automatically start when Mains power On / Off switch is
next turned On. (p. 12)
●
Q-Link or VIERA Link channel download is in progress.
●
The software updating is finished.
●
Perform "System Update Search Now" in System Update (p. 48).
If this is still unsuccessful, there may not be any new software available.
●
If you edit the start time or end time of Guide link recording more than
10 minutes, it will no longer be performed as Guide link recording. The
recording will be performed according to the time setting.
●
Starting time in Timer Programming is already past. Set correctly (p. 51).
●
This message will appear 2 minutes before timer programming event due
∗∗ ∗∗ to start.
:
●
Set Start and End times in Timer Programming correctly (p. 51).
●
Timer programming events are overlapped. If you press the OK button,
the first timer programming event will start and finish, the next timer
programming event can then start.
●
If you want to unlock, cancel Direct TV Recording (p. 66 and p. 68) or
Timer Programming (p. 51).
●
Unable to obtain the IP address. Check the settings and connections of
the router.
●
The tape or disc is active. Stop the equipment and try again.
●
The file is broken or unreadable.
●
The TV does not support the format.
(For the applicable formats and data
●
Confirm SD Card is inserted correctly.
●
The card has no data.
●
Maximum valid number of photos is 9,999.
●
The inserted SD Card has a problem.
●
Your operation is not available.
Meaning / Action
p. 77)