Pioneer LaserDisc CLD-D504 Operating Instruction page 11

NAMES OF PARTS
Remote Control Unit
PowER button (FX))
button
DrsPrAY
button GIQ (FVl
auDlo D/A(Disital/ LIJAI
Analos) button
I P . T 1 4 1 t P . T 1 6 1
reric buttons F9=J
a{=j
I P . T 1 9 l r P . T 2 0 l
k-_.l/--'!l^lz-.\l
RrNooru button GIIQ
lLlrE/lNrRo buttor QR
,LTI-SPEED
button" Q@
SKIP buttons LP.Jt6l
Numeric buttons
LASr MEMoRY button GIril
scaru control G.YQ
Dlsc slDE A/B button" GIr2]
. With some of the PIONEER preset remote con-
trol units. the t/A button in the LD control sec-
tion cannot be used to open/close the disc table.
1 1
< v R B 1 1 4 7 >
button
a Press to cancel repeat mode, program
mode or random olavback or to correct a
mistake made with the numeric buttons.
HILITE/INTRO button
MULTI-SPEED buttons
REPEAT A-B buttons
r: STOP Uutton A@
>: RLaY button fTJi)]
u: PAUsE button Gfa]
>>; SCAN(Fast forwardl
s_.>:
4-:
Operation of the remote control unit
Point the remote control unit loward the remote control sensor
on the front panel. The distance between the player and re-
mote control unit should be less than 7 meters (23 feet) and
the operating angle should be within 30 degrees to the left and
right with respect to the remole control sensor.
To prevent a malfunction, avoid the entry of strong light,
such as direct sunlight and fluorescent light, into the remote
control sensor.
lf the CONTROL lN iack on the rear oanel is connected lo
another component, poant the remote control unit at lhe
remote control sensor oI that component. lt is not possible
to operate the player if the remole control unit is pointed at
the player. lRefer to page 8.)