Understanding Auto Eq Error Messages; Understanding Messages - Pioneer AVH-P8450BT Owner's Manual

Appendix
Additional information
Understanding auto EQ
error messages
When correct measurement of the car's inter-
ior acoustic characteristics is not possible
using auto EQ, an error message may appear
on the display. In such cases, refer to the table
below to see what the problem is and how it
may be corrected. After checking, try again.
Message Cause
Please con- The microphone
nect the mi-
is not connected.
crophone for
measurement.
When fin-
ished, please
push HOME
key.
Error. Please The microphone
check xxxx
cannot pick up
speaker.
the measuring
tone of a speaker.
Error. Please
The surrounding
check noise.
noise level is too
high.
Error. Please
Power is not
check battery.
being supplied
from the battery
to this unit.
104
En
Action
Plug the optional
microphone se-
curely into the
jack.
! Confirm that the
speakers are con-
nected correctly.
! Correct the input
level setting of the
power amp con-
nected to the
speakers.
! Plug the micro-
phone securely
into the jack.
! Stop your car in
a place that is
quiet, and switch
off the engine, air
conditioner and
heater.
! Set the micro-
phone correctly.
! Connect the bat-
tery correctly.
! Check the battery
voltage.

Understanding messages

Messages
Screen image may ap-
pear reversed.
Translation
Pioneer recommends
the use of a camera
which outputs mirror-
reversed images.
Otherwise, the screen
image will appear re-
versed.