Pioneer DV-S77 Operating Insructions page 42

To create your own setting (1):
You can adjust any or all of the following picture quality
factors:
Prog. Motion – When using progressive scan, this
adjusts the motion and still picture quality.
PureCinema – When watching DVD movies,
PureCinema optimizes the picture quality. The
default setting is Auto, but if the picture appears
unnatural, then set to On or Off as desired and
adjust the Prog. Motion setting (see above). See
PureCinema in the glossary starting on page 61.
YNR – Adjusts the amount of noise reduction (NR)
applied to the Y (brightness) component.
CNR – Adjusts the amount of noise reduction (NR)
applied to the C (colour) component.
MNR (Mosquite Noise Reduction) – Adjusts the
amount of noise reduction applied to the mosquito
noise (video artifacts on the edge of the image
resulting from MPEG compression).
BNR (Block Noise Reduction) – Adjusts the amount
of noise reduction applied to the block noise.
Sharpness High – Adjusts the sharpness of the
high-frequency (finely detailed) elements in the
picture.
Sharpness Mid – Adjusts the sharpness of the mid-
frequency (less detailed) elements in the picture.
Detail – Adjusts how sharp edges appear in the
picture.
White Level – Adjusts the intensity of white in the
picture.
Black Level – Adjusts the intensity of black in the
picture.
Black Setup – For correction of floating black
colour.
Hue – Adjusts the overall colour balance between
red and green.
Chroma Level – Adjusts how saturated colours
appear.
Chroma Delay – Compensates for misalignment of
the Y (brightness) and the C (colour) components.
5
Move the cursor control joystick right or
left to adjust the settings.
If a DVD or Video CD is playing, the changes will be
visible on the screen as they are adjusted.
6
Repeat steps 4 and 5 to make adjustments
to other settings.
If you would like to save the settings in the player's
memory, be sure to select either "1", "2", or "3" in
the [Memory] setting to establish which memory
location to save the new settings in. Please note
that if you select a location where settings have
already been saved, the old settings will be
replaced by the new ones.
Memory
42
Off 1 2 3
Move Select Check
ENTER DISPLAY
7
When you are finished making
adjustments, press ENTER to establish the
new settings.
To create your own setting (2):
1
Press VIDEO ADJUST (V.ADJ).
Video Memory Select
Video Setup
2
Select Video Setup, then press ENTER.
Prog.Motion
Move
3
Press DISPLAY.
4
Move the cursor control joystick up or
down to select a setting; move it left or
right to adjust that setting.
Prog.Motion
PureCinema
YNR
CRN
MNR
BNR
Sharpness High
Sharpness Mid
Memory
Detail
White Level
Black Level
Black Setup
Hue
Chroma Level
Chroma Delay
Memory
Adjust these while a disc is playing to see the effect of
changes immediately.
5
To memorize the setting, select memory 1,
2 or 3, then press ENTER.
The previous setting will be erased.
fast Slow
ENTER Select DISPLAY Check
Page 1/2
fast Slow
Auto On Off
off max
off max
off max
off max
fine
soft
soft fine
Off 1 2 3
Page 2/2
max
off
min max
max
min
0 IRE 7.5 IRE
red
green
min max
– +
Off 1 2 3