Operating Range Of The Remote Control - Pioneer VSX-C402 Operating Insructions

Controls and displays
SURROUND
Use to select a SURROUND mode for the current
source.
ADVANCED SURROUND
Use to select an ADVANCED SURROUND mode for
the current source.
SOUND MODE
Use to select a SOUND MODE for the current
source.
DIALOG
Press to switch on/off DIALOG (dialog
enhancement).
10 MUTE
Press to mute all output. Press again (or adjust the
volume using the MASTER VOLUME control) to restore
the sound.
11 VIRTUAL SB (page 25)
Press to select virtual surround options.
12 MASTER VOLUME
Use to adjust the volume.
13 ROOM SETUP (page 22)
Use to select a preset room setup.
14 SYSTEM SETUP (page 32)
Press to access the SYSTEM SETUP menu to make
detailed receiver settings.
15 Cursor keys and ENTER
Use to navigate menus and select options/execute
commands.
16 CH SELECT (page 35)
First press RECEIVER, then press CH SELECT repeatedly
to select a speaker channel to adjust.
17 TEST TONE (page 35)
First press RECEIVER, then press TEST TONE to start/
stop the test tone.
18 Playback controls (page 38)
Playback controls for external components, such as DVD
and CD players.
Functions printed in blue control the built-in tuner; other
functions control other external equipment.
19 Number buttons (page 38)
Use for numerical input of track numbers, radio
frequencies, and so on.
20 CHANNEL +/– (page 38)
Use to change channels on a satellite receiver, cable box,
VCR or DVR.
21 DIMMER
First press RECEIVER, then press DIMMER repeatedly to
change the brightness/switch off the front panel display.
The display will light brightly for about two seconds when
you operate the receiver with the display off or dimmed.
(Note that the master volume indicator always remains
lit, even when the rest of the display is off.)
22 TV CONTROL buttons (page 39)
Use to control your TV (after setting up the remote control
to work with your TV).
23 SLEEP (page 30)
First press RECEIVER, then press SLEEP repeatedly to put
the receiver into sleep mode and select the length of time
before the receiver turns off.

Operating range of the remote control

The remote control may not work properly if:
• There are obstacles between the remote control and
the receiver's remote sensor.
• Direct sunlight or fluorescent light is shining onto the
remote sensor.
• The receiver is located near a device that is emitting
infrared rays.
• The receiver is operated simultaneously with another
infrared remote control unit.
30
30
7m
04
21
En