Checking What's In The Box; Installing The Receiver; Loading The Batteries; Operating Range Of Remote Control Unit - Pioneer VSX-922-K Operating Instructions Manual

01

Checking what's in the box

Please check that you've received the following supplied accessories:
! Setup microphone (cable: 5 m)
! Remote control unit
! AAA size IEC R03 dry cell batteries (to confirm system operation) x2
! AM loop antenna
! FM wire antenna
! iPod cable
! Power cord
! CD-ROM (AVNavigator)
! Quick start guide
! Safety Brochure

Installing the receiver

! When installing this unit, make sure to put it on a level and stable surface.
! Don't install it on the following places:
— on a color TV (the screen may distort)
— near a cassette deck (or close to a device that gives off a magnetic field). This may interfere with the sound.
— in direct sunlight
— in damp or wet areas
— in extremely hot or cold areas
— in places where there is vibration or other movement
— in places that are very dusty
— in places that have hot fumes or oils (such as a kitchen)
! Do not touch this receiver's bottom panel while the power is on or just after it is turned off. The bottom panel
becomes hot when the power is on (or right after it is turned off) and could cause burns.

Loading the batteries

The batteries included with the unit are to check initial operations; they may not last over a long period. We rec-
ommend using alkaline batteries that have a longer life.
WARNING
! Do not use or store batteries in direct sunlight or other excessively hot place, such as inside a car or near a
heater. This can cause batteries to leak, overheat, explode or catch fire. It can also reduce the life or perfor-
mance of batteries.
CAUTION
Incorrect use of batteries may result in such hazards as leakage and bursting. Observe the following precautions:
! Never use new and old batteries together.
! Insert the plus and minus sides of the batteries properly according to the marks in the battery case.
! Batteries with the same shape may have different voltages. Do not use different batteries together.
! When disposing of used batteries, please comply with governmental regulations or environmental public insti-
tution's rules that apply in your country/area.
(Symbol examples for batteries)

Operating range of remote control unit

The remote control may not work properly if:
! There are obstacles between the remote control and the receiver's remote sensor.
! Direct sunlight or fluorescent light is shining onto the remote sensor.
! The receiver is located near a device that is emitting infrared rays.
! The receiver is operated simultaneously with another infrared remote control unit.

Selecting the OSD character set

Select the character set to be used for displaying the receiver's OSD. When 'Latin' is selected, English, French,
German, Italian, Spanish, Dutch and Russian can be selected for the OSD Language setting
'Chinese' is selected, Chinese becomes selectable for the OSD Language setting
To change the OSD character set, perform the operations on the front panel. When using the multi-zone function,
set MULTI ZONE OFF before performing the operations below.
1 Switch the receiver into standby.
2 While holding down ENTER on the front panel, press u STANDBY/ON.
The display shows RESET c NO d.
3 Select 'FONT' using TUNE i/j.
4 Use PRESET k/l to select 'Latin' or 'Chinese' then press ENTER on the front panel.
The display shows CHANGE? [OK].
5 Press ENTER to confirm.
'OK' is displayed and the receiver automatically restarts.
To change the OSD language to something other than English, change the OSD Language setting. For details,
see Changing the OSD display language (OSD Language)
7
Before you start
These symbols are only valid
in the European Union.
Pb
K058c_A1_En
30°
30°
7 m
(page
(page 32).
on page 32.
32). When