Advertisement
OFF ROAD TRUCK LIGHT SYSTEM
Copyright
manual or any artwork contained herein may be reproduced in any shape or form
You will need this Instruction Manual for the safety warnings and precautions, assembly/ inspec-
tion/maintenance information, and assembly diagram. Keep your invoice with this Instruction
Manual. Write the invoice number on the front page. Keep this Instruction Manual and invoice in
a safe and dry place for future reference.
GENERAL SAFETY WARNINGS AND PRECAUTIONS
1.
Use eye protection. Wear ANSI approved safety impact eye goggles when assembling this product.
ANSI approved safety impact eye goggles are available from Harbor Freight Tools.
2.
Use the right tool or attachment for the job. There are certain applications for which this product
was designed. Do not modify this product, and do not use this product for a purpose for which it was
not intended.
3.
Replacement parts and accessories: When servicing, use only identical replacement parts. Only
use accessories intended for use with this product.
4.
The Off Road Truck Light System is for OFF ROAD use only. Check with local and/or State
regulations regarding installation and use of this product on your vehicle.
5.
WARNING! Vehicles equipped with airbags may have the sensors located inside the front bumper.
Make sure to consult the vehicle owner's manual to determine the location of the airbag sensors. To
avoid damaging the sensors if they are located in the front bumper, do not drill holes in the bumper.
6.
The 100 Watt Halogen Lamps become extremely hot under continuous use. Do not touch the
Lamps for at least 30 minutes after turning off the Lamps.
7.
Turn off the Off Road Light System, disconnect its Power Cord from its 12 Volt DC Battery, and allow
its Halogen Lamps to completely cool down prior to performing any inspection, maintenance, or
cleaning on the unit.
8.
WARNING! The warnings, precautions, and instructions discussed in this manual cannot cover all
possible conditions and situations that may occur. The operator must understand that common sense
and caution are factors which cannot be built into this product, but must be supplied by the operator.
Model 03029
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http//www.harborfreight.com
©
2003 by Harbor Freight Tools
without the express written consent of Harbor Freight Tools.
For technical questions, please call 1-800-444-3353.
SAVE THIS INSTRUCTION MANUAL
®
. All rights reserved. No portion of this
®
MANUAL REV 04/05
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Harbor Freight Tools 3029
Summary of Contents for Harbor Freight Tools 3029
- Page 1 Use eye protection. Wear ANSI approved safety impact eye goggles when assembling this product. ANSI approved safety impact eye goggles are available from Harbor Freight Tools. Use the right tool or attachment for the job. There are certain applications for which this product was designed.
-
Page 2: Assembly Instructions
When unpacking, check to make sure all the parts shown are included. If any par ts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible. To avoid accidental short circuits, disconnect the negative (-) terminal of the vehicle battery prior to assembling the Off Road Truck Light System. - Page 3 BLACK GROUND WIRE FIGURE B INSPECTION AND MAINTENANCE WARNING! Always unplug the Off Road Truck Light System from its 12 Volt DC power source and allow the unit to completely cool down before performing any inspection or maintenance. BEFORE EACH USE, inspect the general condition of the Off Road Truck Light System. Check for misalignment or binding of moving parts, cracked or broken parts, damaged Wiring, damaged Lens/ Lens Guard, and any other condition that may affect its safe operation.
Need help?
Do you have a question about the 3029 and is the answer not in the manual?
Questions and answers