Panasonic KX-TG9120E Operating Instructions Manual page 60

TG9120_40_50E(e).book Page 60 Wednesday, August 2, 2006 4:54 PM
Useful Information
Problem
I cannot make or receive calls.
I cannot receive a call from the
monitored handset.
The unit does not ring.
The batteries should be charging
but the battery icon does not
change.
A busy tone is heard when {C} is
pressed.
Static is heard, sound cuts in and
out. Interference from other
electrical units.
60 Helpline Tel. No.: U.K. 08700 100 076 R.O.I. 01289 8333
Cause & solution
L The AC adaptor or telephone line cord is not
connected. Check the connections.
L If you are using a splitter to connect the unit,
remove the splitter and connect the unit to the wall
socket directly. If the unit operates properly, check
the splitter.
L Disconnect the base unit from the telephone line
and connect the line to a known working telephone.
If the working telephone operates properly, contact
our service personnel to have the unit repaired. If
the working telephone does not operate properly,
contact your service provider/telephone company.
L You dialled a call restricted number (page 36).
L The key lock feature is turned on. Turn it off (page
18).
L Make sure the monitoring handset is not on any of
the following calls:
– Intercom call
– Cordless camera monitoring call (Cordless
camera KX-TGA914E users only)
– Internet call (USB adaptor KX-TGA915EX users
only)
– Doorphone call (Doorphone users only)
L The ringer volume is turned off. Adjust the ringer
volume (page 28, 35).
L The night mode feature is turned on. Turn it off
(page 30, 35).
L Clean the charge contacts and charge again (page
14).
L The handset is too far from the base unit. Move
closer and try again.
L Another handset is in use or the answering system
is being used. Wait and try again later.
L Place the handset and the base unit away from
other electrical appliances.
L Move closer to the base unit.
L Your unit is connected to a telephone line with DSL
service. We recommend connecting a filter (contact
your DSL service provider) to the telephone line
between the base unit and the telephone line jack.