Table of Contents
Advertisement
First-time Operation
CAUTION
After the cover is closed, press down firmly on the cover and con-
firm that the cover is locked.
Handling the AC adaptor
Do not twist or pull the AC power cord forcefully. Doing so may damage the
connections.
Use only the specified AC adaptor with your computer. Using an AC adaptor other
than the one supplied might damage the battery and/or the computer.
When the DC plug is not connected to the computer, disconnect the AC cord from
your AC wall outlet.
Problems such as sudden voltage drops may arise during periods of thunder and
lightning storms. Since this could adversely affect your computer, an uninterruptible
power source (UPS) is highly recommended unless the battery pack is installed.
3
Turn your computer on
(1) Push the reset switch using the stylus.
(2) At the confirmation message, press Y .
The Windows* calibration screen is displayed.
(3) Calibrate the touchscreen.
(For calibration, tapping operations are required. For
information on tapping, refer to page 15.)
"+" is displayed in the center, upper left, lower left,
lower right, and upper right portions of the screen, in
that order. Each time the "+" mark is displayed, tap the
center of the "+" mark with the stylus.
After the calibration procedure is executed (i.e., after
the five "+" marks are touched), the procedure ends
when
(4) Input the correct date, time and time zone and tap [Ap-
ply] or [OK] for your settings to take effect.
(5) Adjust the LCD brightness. (
computer
* This
This concludes the first-time use operation guidelines.
12
is pressed.
®
uses Microsoft
Windows
page 16)
®
CE Operating System.
Reset Switch
Advertisement
Table of Contents
