Clean The Battery And Terminals - Cub Cadet Sc2400 Operator's Manual

2. Install the Battery
1. Install the battery onto the tractor.
2. Connect the black positive (+) cable to the battery
and then put the red positive terminal cover on
the terminal.
3. Install the threaded rods and bracket and,
retighten the nuts. Avoid over-tightening.
4. Connect the black/yellow negative (–) cable.
5. Apply petroleum jelly to the battery terminals to
protect them against corrosion.
6. Close the rear grille screen.

■ Clean the Battery and Terminals

1. Disconnect the battery cables, black/yellow
negative (–) cable first, and remove the battery.
2. Dissolve four tablespoons of baking soda in 1
gallon of water to prepare a solution. Use this
solution to wash the battery. Be very careful not to
allow the solution to enter the battery cells.
3. Rinse the battery with water and allow it to dry.
4. Clean the terminals and battery cable ends with
wire brush to remove corrosion.
5. Apply petroleum jelly or silicone spray to the
battery terminals to protect them against
corrosion.
6. Install the battery.
7. Connect the black positive (+) cable first, then
connect the black/yellow negative (–) cable.
15. SERVICE THE ELECTRICAL SYSTEM
15-4
Sc2400 Operator's Manual