Radio Reception; Tuning To Radio Stations; Programming Radio Stations; Automatic Programming - Philips MCD396 User Manual

Radio Reception

Tuning to radio stations

1
Press SOURCE on the set or TUNER on the
remote repeatedly until the desired waveband
(FM) is displayed.
2
Press and hold TUNING 22/33 and release
the button.
➜
The radio automatically tunes to a station
with sufficient reception.
3
Repeat step 2 if necessary until you find the
desired station.
●
To tune to a weak station, press TUNING
22/33 briefly and repeatedly until you have
found optimal reception.

Programming radio stations

You can store up to a total of 40 radio stations
in the memory.

Automatic programming

Automatic programming will start with a chosen
preset number. From this preset number
upwards, former programmed radio stations will
be overridden.
1
Press PRESETí/ë to select the preset
number where programming should start.
32
Note:
– If no preset number is selected, default is preset
(1) and all your presets will be overridden.
2
Press PROG/ANGLE on the remote for more
than three seconds to activate programming.
➜
All available stations are programmed.

Manual programming

1
Tune to your desired station (refer to "Tuning to
radio stations").
2
Press PROG/ANGLE to activate
programming.
➜
PROG flashes on the display.
3
Press PRESETí/ë to allocate a number
from 1 to 40 to this station.
4
Press PROG/ANGLE again to confirm the
setting.
➜
PROG disappears.
5
Repeat the four steps above to store other
stations.
●
You can overwrite a preset station by storing
another frequency in its place.

Tuning to preset radio stations

●
Press PRESETí/ë until the desired preset
station is displayed.
TAPE USB/AUX