Table of Contents
Advertisement
Hints:
• Cut the ingredients into approx. 3 cm size pieces
before adding them to the bowl 9.
• The appliance chops the ingredients very fast,
therefore allow the appliance to run only briefly.
• Do not allow the appliance to run for more than
1 minute at a time.
• Should the ingredients get caught up in the bowl
9 or between the blades z:
- Switch off the appliance.
- Remove the lid 0 from the mixing bowl 9.
- Remove the ingredients with a spatula o.
7.2 Remove the cutting and grating
blades from the accessory clip
• Remove the blender lid 2
from the blender jug 4 by
turning it clockwise.
• Grasp the accessory clip 3
on the handle at the centre of
the retainer 3 with the thumb
and index finger.
• Pull the accessory clip 3 with the cutting and
grating discs (I-VI) out of the blender jug 4.
• Remove the cutting and
grating discs (I-VI) from the
holder 3.
7.3 Insert the cutting and grating discs
back into the accessory clip
Make sure that all the cutting edges are pointing in-
wards.
7.4 Working with the cutting and gra-
ting discs
Caution:
• The cutting edges are very sharp! Exercise inser-
ting and removing or cleaning the discs!
• Never use your fingers, spatula, spoon handles
or similar objects for pushing foodstuff through
the filling shaft q!
- 5 -
• Insert the cutting discs (II/III)
in the retainer slots. Begin
with the inner retainer
slots.The lateral flaps with the
elevation in the middle must
point upwards.
• Place the shredder (IV/V),
grater (I) and potato-chips
disc (VI) in the storage slot on
the outside.
• Place the accssory clip 3
back in the blender jug 4.
Ensure that the rails on the ac-
cessory mounting 3 grip
firmly into the shoulders of the
mixing container 4.
• Place the cover 2 on the li-
quidiser 4 so that the arrows
on the handle of the liquidiser
4 and on the cover 2 point
towards each other. Turn the
cover 2 anti-clockwise until it
sits firmly.
Hide quick links:
Advertisement
Table of Contents
