Using two AF360FGZ flash units with one
attached to the camera.
Main flash
R
This flash is used only for controlled firing and not
for the main flash.
40
Flash unit on camera
35
mm
CONTROL
P-TTL
A.Zoom
mm
1
2
1
Attach the AF360FGZ flash unit to the camera.
Set the flash unit's power switch to WIRELESS.
q Set the flash power switch to [WIRELESS]
w Set the WIRELESS mode switch to [C].
• This flash unit will operate only to trigger the
other flash unit to fire. It will not fire a real flash
itself.
WIRELESS FLASH
35
mm
SLAVE
P-TTL
mm
M.Zoom
5
4
3
1
2
2
Place the other flash unit(s) at the desired
location(s).
q Set the power switch to WIRELESS.
w Set the wireless mode switch to slave [S].
e Slide down the setting switch to [yellow dot].
Next, press the channel button [CH] and set
the same channel as the AF360FGZ being
attached then slide the setting switch back
up.
r Press the flash mode button and set to P-
TTL.
t Set the zoom position with Manual [M.
Zoom].
3
Check that the flash unit on the camera and the
slave flash unit(s) are ready, then take the
picture.
• The two flash units must be set to the same
channel otherwise the flash unit separated
from the camera will not fire.
41