Makita HP1620 Instruction Manual
Hide thumbs
Also See for HP1620:
- Instruction manual (45 pages) ,
- Technical information (12 pages) ,
- Instruction manual (8 pages)
Table of Contents
Related Manuals for Makita HP1620
Summary of Contents for Makita HP1620
- Page 1 Hammer Drill MODEL HP1620 MODEL HP1620F MODEL HP1621 MODEL HP1621F 004358 DOUBLE INSULATION I N S T R U C T I O N M A N U A L WARNING: For your personal safety, READ and UNDERSTAND before using.
-
Page 2: Specifications
Responsible manufacturer: metal, ceramic and plastic. Makita Corporation Anjo Aichi Japan Power supply The tool should be connected only to a power supply of the same voltage as indicated on the nameplate, and can only be operated on single-phase AC supply. -
Page 3: General Safety Rules
GENERAL SAFETY RULES GEA001-3 WARNING: Read all instructions. Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury. The term “power tool” in all of the warnings listed below refers to your mains-operated (corded) power tool or battery- operated (cordless) power tool. -
Page 4: Specific Safety Rules
19. Store idle power tools out of the reach of chil- the manner intended for the particular type of dren and do not allow persons unfamiliar with power tool, taking into account the working con- the power tool or these instructions to operate ditions and the work to be performed. -
Page 5: Functional Description
FUNCTIONAL CAUTION: DESCRIPTION • Always be sure that the tool is switched off and unplugged before adjusting or checking function on the tool. Switch action 004359 CAUTION: • Before plugging in the tool, always check to see that the switch trigger actuates properly and returns to the “OFF”... - Page 6 The side grip cannot swing 360° when the depth gauge is installed. 1. Side grip Installing or removing drill bit For Model HP1620, HP1620F 004364 To install the bit, place it in the chuck as far as it will go. Tighten the chuck by hand.
-
Page 7: Operation
Depth gauge 004366 The depth gauge is convenient for drilling holes of uniform depth. Loosen the side grip and insert the depth gauge into the hole in the side grip. Adjust the depth gauge to the desired depth and tighten the side grip. NOTE: •... -
Page 8: Maintenance
Always be sure that the tool is switched off and unplugged before attempting to perform inspection or maintenance. To maintain product SAFETY and RELIABILITY, repairs, carbon brush inspec- tion and replacement, any other maintenance or adjustment should be per- formed by Makita Authorized Service Centers, always using Makita replacement parts. - Page 9 CAUTION: • These accessories or attachments are recommended for use with your Makita tool specified in this manual. The use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or attachment for its stated purpose.
- Page 10 Memo...
- Page 11 Memo...
- Page 12 Makita Corporation Anjo, Aichi, Japan 884507C228...