Makita HR1830 Instruction Manual page 7

1
2
1. Bit shank
2. Bit grease
1
1. Bit
2. Chuck cover
1
1. Bit
2. Chuck cover
1
2
3
1. Depth gauge
2. Hole of grip base
3. Loosen
4. Tighten
Installing or removing the bit
001296
Clean the bit shank and apply bit grease before installing the bit.
Insert the bit into the tool. Turn the bit and push it in until it engages.
007233
After installing, always make sure that the bit is securely held in place by trying
to pull it out.
2
To remove the bit, pull the chuck cover down all the way and pull the bit out.
007234
2
Depth gauge
007235
The depth gauge is convenient for drilling holes of uniform depth. Loosen the
4
side grip and insert the depth gauge into the hole in the side grip. Adjust the
depth gauge to the desired depth and tighten the side grip.
NOTE:
• The depth gauge cannot be used at the position where the depth gauge
strikes against the gear housing.
7