Table of Contents
Advertisement
RTP Setting
Have a setting for sending and receiving an audio or video on a real-time basis.
Stream RTP after camera start-up
Enter a destination IP and Port to send movie data automatically through the RTP while the Network
Camera has booting.
Send to DHCP server IP: Send movie data to the DHCP server.
Send to (Client) IP: Send movie data to other certain destination addresses.
Use RTP destination Port: Available from 1024 to 65532, and the default is 5000.
Do not send: Do not send a stream to the FTP until it is requested from a client.
□ Enable multi stream: Check it to send data for the purpose of saving them into an external
extension storage right after the Network Camera operates.
-Send to secondary client ip: Enter an IP address of the external extension storage.
-Use RTP destination port: Enter a Port number of the external extension storage.
The Port number to be used is [1024 ~ 65532].
-Frame rate: Indicate a frame rate that is sent to the external extension storage when the multi
stream works.
- 40 -
Advertisement
Table of Contents
