Using The Wired Remote Control; Using The Unit With Optional Accessories; Product Service; Product Information - Panasonic SL-SX276J Operating Instructions Manual

Using the Wired Remote Control

The remote control can be operated regardless of the
HOLD mode of the unit.
Preparation:
Release the remote control from the HOLD mode.
HOLD
∫ Operation confirmation tones
»
When an operation button is pressed, a confirmation
tone sounds. Refer to the parentheses in the illustra-
tion for the different types of confirmation tones.

Using the Unit with Optional Accessories

Using the unit with an audio
system
Using stereo connection cable (not included), you can
listen to CDs on your audio system.
≥Connect the cable to the amplifier after turning off its
power.
≥Do not connect the cable to the PHONO jacks on the
amplifier.
≥Obtain the optional connecting cable if the amplifier
comes with mini-phone jacks.
≥Adjust the volume on the amplifier.
≥Set the unit's volume between 4 and 6.
≥You can connect speakers, active or otherwise, with
an impedance of 1 k≠ or less to the headphone jack.
Headphone jack (Ë)
(White)
L
R
(Red)
Stereo connection cable (not included)
5
How to use the wired remote control
To start play
To stop play
To turn off
the unit
Using the unit with a car audio
system
Items to be purchased
For connection to the car audio system
Car stereo cassette adaptor (SH-CDM10A)
Connect the car stereo cassette adaptor to the
unit's headphone jack.
(When doing this, keep the unit's VOLUME at a
setting between 4 and 6.)
For securing the unit and connecting the power
supply:
≥Car adaptor (SH-CDC9)
≥Car mounting kit (SH-CDF20)
Note!
It may not be possible to use the unit with some types of
car stereos owing to restrictions imposed by the con-
struction of the car stereo cassette adaptor.
For further details, refer to the instructions of the part
concerned.
Note when using the car mounting kit (SH-CDF20)
Amplifier
To CD or AUX
terminals
Press once during off or stop mode.
(Beep)
Press once during play.
(Beep...Beep)
Press and hold during play or stop mode.
(Beep...Bee...p)
Bracket
1Remove the screw from
the bracket at the rear
of the car mounting
base.
2Replace the screw in the
lower hole of the bracket.
Screwdriver
Press once during play.
Skipping
tracks
Searching
through tracks
Press and hold during play.
When adjusting the volume using the remote
control, position the volume control on the
unit between 4 and 6.
To adjust the
volume
Maintaining the
Lens
Open the lid and clean the lens as shown in the figure.
Use a cotton swab to gently wipe off any finger-prints.
Recommended product: Lens cleaner kit (SZZP1038C)
Lens
Air blower for
camera lens

Product Service

Do not attempt to remove the cover(s) or repair the unit
yourself. Refer servicing to qualified personnel only.

Product information

For product service, product information or assistance
with product operation, refer to the servicenter directory.
User memo:
DATE OF PURCHASE
DEALER NAME
DEALER ADDRESS
TELEPHONE NUMBER
Forward
(Beep Beep)
Backward
(Beep Beep Beep)
Lens
RQT5442