Table of Contents
Advertisement
10. Press {e} or {v} repeatedly to select the
desired setting.
"ONCE": Alarm will ring only once.
"REPEAT DAILY": Alarm will ring at the set
time everyday.
"OFF" (default): Deactivates this feature.
11. Press {>} or {j}.
12. Press {ih}.
Note:
L Time alarm will sound for 3 minutes.
L To stop the alarm, press any dialling buttons.
L When in talk or intercom mode, the alarm will
not sound until the call is ended.
Changing the time alarm frequency
1. Press {j}.
2. Press {e} or {v} repeatedly to display
"SETTING HS".
3. Press {>}.
4. Press {e} or {v} repeatedly to display
"TIME ALARM".
5. Press {>}.
6. Press {e} or {v} repeatedly to display "SET
ALARM".
7. Press {>}.
8. Press {e} or {v} to select "ONCE", "REPEAT
DAILY" or "OFF".
9. Press {>} or {j}.
10. Press {ih}.
Ringer option settings
You can select the following ringer settings.
Ringer volume: See page 21.
Ringer patterns for external calls / internal
calls / paging / alarm: There are 20 patterns
available for each ringer. To change the ringer
patterns, proceed as follows.
1. Press {j}.
2. Press {e} or {v} repeatedly to display
"SETTING HS".
3. Press {>}.
4. Press {e} or {v} repeatedly to display
"RINGER OPT".
5. Press {>}.
6. Press {e} or {v} repeatedly to display the
desired item.
For external calls, select "EXT RINGER".
For internal calls, select "INT RINGER".
7. Programmable Features
For paging, select "PAGING".
For alarm, select "ALARM".
7. Press {>}.
8. Press {e} or {v} repeatedly to select the
desired setting from pattern "1" (default) to
"20".
9. Press {>} or {j}.
10. Press {ih}.
Note:
L If you select one of the melody ringer
patterns, the ringer will continue to sound for
10 seconds when the caller hangs up before
you answer. You may hear a dial tone or no
one on the line when you answer a call.
Tone option settings
You can set the following tone/alarm on or off.
Key tone: Key tones, a confirmation tone or an
error tone will sound. The default setting is "ON".
Call waiting tone: A call waiting tone will sound
when an external call is received during an
intercom call. The default setting is "ON".
Range warning alarm: An alarm will sound
when you move out of range of a base unit. The
default setting is "OFF".
Battery low alarm: An alarm will sound when
the batteries need to be charged. The default
setting is "ON".
1. Press {j}.
2. Press {e} or {v} repeatedly to display
"SETTING HS".
3. Press {>}.
4. Press {e} or {v} repeatedly to display
"TONE OPT".
5. Press {>}.
6. Press {e} or {v} repeatedly to display the
desired item.
For the key tone, select "KEY TONE".
For the call waiting tone, select "CALL
WAITING".
For the range warning alarm, select
"RANGE ALARM".
For the battery low alarm, select "BATTERY
LOW".
7. Press {>}.
8. Press {e} or {v} repeatedly to select "ON"
or "OFF".
9. Press {>} or {j}.
10. Press {ih}.
55
Advertisement
Table of Contents
