Operation; Maintenance - Makita 5007NB Instruction Manual

OPERATION

1
3
1. Rear handle
2. Front grip
3. Base
1
1. Rip fence (Guide rule)

MAINTENANCE

1
1. Adjusting screw
2. Base
8
CAUTION:
• Be sure to move the tool forward in a straight line gently. Forcing or
twisting the tool will result in overheating the motor and dangerous
kickback, possibly causing severe injury.
Hold the tool firmly. The tool is provided with both a front grip and rear handle.
001460
Use both to best grasp the tool. If both hands are holding saw, they cannot be
2
cut by the blade. Set the base on the workpiece to be cut without the blade
making any contact. Then turn the tool on and wait until the blade attains full
speed. Now simply move the tool forward over the workpiece surface, keeping
it flat and advancing smoothly until the sawing is completed.
To get clean cuts, keep your sawing line straight and your speed of advance
uniform. If the cut fails to properly follow your intended cut line, do not attempt
to turn or force the tool back to the cut line. Doing so may bind the blade and
lead to dangerous kickback and possible serious injury. Release switch, wait
for blade to stop and then withdraw tool. Realign tool on new cut line, and start
cut again. Attempt to avoid positioning which exposes operator to chips and
wood dust being ejected from saw. Use eye protection to help avoid injury.
Rip fence (Guide rule)
001480
The handy rip fence allows you to do extra-accurate straight cuts. Simply slide
the rip fence up snugly against the side of the workpiece and secure it in posi-
tion with the screw on the front of the base. It also makes repeated cuts of uni-
form width possible.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
attempting to perform inspection or maintenance.
Adjusting for accuracy of 90° cut (vertical cut)
001496
This adjustment has been made at the factory. But if it is off, adjust the adjust-
2
ing screw with a hex wrench while squaring the blade with the base using a tri-
angular rule, try square, etc.