Makita 5007NB Instruction Manual page 7

1. Switch trigger
ASSEMBLY
1
1. Wrench
2. Shaft lock
1
2 3
1. Saw blade
2. Hex bolt
3. Outer flange
4. Inner flange
Switch action
001396
1
CAUTION:
• Before plugging in the tool, always check to see that the switch trigger
actuates properly and returns to the "OFF" position when released.
To start the tool, simply pull the switch trigger. Release the switch trigger to
stop.
CAUTION:
• Always be sure that the tool is switched off and unplugged before
carrying out any work on the tool.
Removing or installing saw blade
001417
CAUTION:
• Be sure the blade is installed with teeth pointing up at the front of the
tool.
• Use only the Makita wrench to install or remove the blade.
To remove the blade, press the shaft lock so that the blade cannot revolve and
2
use the wrench to loosen the hex bolt counterclockwise. Then remove the hex
bolt, outer flange and blade.
To install the blade, follow the removal procedure in reverse. BE SURE TO
001434
TIGHTEN THE HEX BOLT CLOCKWISE SECURELY.
4
7