How To Connect The Pc Input Terminal - Panasonic TH-37PV500B Operating Instructions Manual

Connections

How to connect the PC Input terminal

Example:
COMPUTER
Conversion adapter (if necessary)
Ferrite core (Large size)
Notes:
• Connect a cable which matches the audio output terminal on the computer.
• Computer signals which can be input are those with a horizontal scanning frequency of 31 to 69 kHz and vertical
scanning frequency of 59 to 86 Hz. (However, the image will not be displayed properly if the signals exceed 1,024
lines.)
• The display resolution is a maximum of 768 × 720 dots (TH-37PV500B), 768 × 768 dots (TH-42PV500B), 1,024
× 768 dots (TH-50PV500B) when the aspect mode is set to "4:3", and 1,024 × 720 dots (TH-37PV500B), 1,024 ×
768 dots (TH-42PV500B), 1,366 × 768 dots (TH-50PV500B) when the aspect mode is set to "16:9". If the display
resolution exceeds these maximums, it may not be possible to show fi ne detail with suffi cient clarity.
• Some PC models cannot be connected to the set.
• There is no need to use an adapter for computers with DOS/V compatible D-sub 15P terminal.
• The computer shown in the illustration is for example purposes only.
• Additional equipment and cables shown are not supplied with this set.
• Do not set the horizontal and vertical scanning frequencies for PC signals which are above or below the specifi ed
frequency range.
• For applicable PC signals information see page 58.
Signal Names for D-sub 15P Connector
5 4 3 2 1
10 9 8 7 6
15 14 13 12 11
Pin Layout for PC Input
Terminal
Less than
10 cm
RGB
AUDIO
Pin No. Signal Name
R
1
G
2
B
3
NC (not connected)
4
GND (Ground)
5
(D-sub 15p)
L
PC
R
(Stereo plug)
PC IN
AUDIO IN
Pin No. Signal Name
GND (Ground)
6
GND (Ground)
7
GND (Ground)
8
NC (not connected)
9
GND (Ground)
10
AV
AUDIO AUDIO
L L
R R
AUDIO
IN
RGB
AV1 AV2 AV4 VIDEO
VIDEO RGB
VIDEO S VIDEO S VIDEO
Pin No. Signal Name
NC (not connected)
11
NC (not connected)
12
HD/SYNC
13
VD
14
NC (not connected)
15
COMPONENT
VIDEO
Y
P
B
P
R
55