Panasonic TH-37PV500B Operating Instructions Manual page 39

PC mode
Setup menu
In PC mode
Press the MENU button.
Move to Setup menu.
Access Setup menu.
Move to menu option.
Adjust chosen option or access chosen menu.
Press the EXIT button at any time to exit Setup menu.
PC setup Access to adjust chosen option.
Input : Displayed during VGA(640 × 480 dots), WVGA(852 × 480 dots), XGA(1,024 × 768 dots),
resolution WXGA(1,366 × 768 dots) input signals.
Select WVGA or WXGA during WVGA or WXGA input signal to avoid noise.
Clock : If a periodic striped pattern (noise) occurs, carry out adjustments to reduce the noise to the
lowest level.
H-pos : Adjust the horizontal position.
V-pos : Adjust the vertical position.
Clock phase : Eliminate the fl ickering and distortion.
Carry out this adjustment after adjusting Clock.
Adjust to reduce noise to the most inconspicuous level.
Sync : H & V - To synchronize by the horizontal and vertical signals from your PC.
on G - To synchronize by the green signal form your PC (if available).
Volume correction, Side panel, Power save
About settings, see page 15.
H-freq. / V-freq.
If the input signal is not applicable, the characters will turn to red.
For applicable PC signals information see page 58.
Main menu
MENU
P i c t u r e menu
Setup menu
PC setup
Volume correction
Side panel
Power save
PC setup
EXIT
Input resolution
Clock
H-pos
V-pos
Clock phase
Sync
Sound menu
Setup menu
Access
Off
Off
VGA
H & V
39