Makita 1923H Instruction Manual page 12

1
2
3
1. Wing nut
2. Blade (A)
3. Blade (B)
4. Side (D)
5. Side (C)
1. Limit mark
1
2
1. Rear cover
2. Screwdriver
12
First, loosen the two wing nuts on the holder and insert the blades (A) and (B),
002589
so that they contact the sides (C) and (D). Then tighten the wing nuts.
5
4
Immerse the dressing stone in water for 2 or 3 minutes before sharpening.
002590
Hold the holder so that the both blades contact the dressing stone for simulta-
neous sharpening at the same angle.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the rear cover.
004904