Specifications - Makita 4112HS Instruction Manual

SPECIFICATIONS

Model
Wheel diameter
Max cutting capcity
-1
No load speed (min
Overall length
Net weight
Safety class
• Due to our continuing programme of research and development, the specifications herein are subject to change
without notice.
• Note: Specifications may differ from country to country.
SYMBOLS
The following show the symbols used for the equipment.
Be sure that you understand their meaning before use.
...................Read instruction manual.
...................DOUBLE INSULATION
..................Only for EU countries
Do not dispose of electric equipment
together
material!
In observance of European Directive
2002/96/EC on waste electric and
electronic
implementation in accordance with
national law, electric equipment that
have reached the end of their life
must be collected separately and
returned
compatible recycling facility.
Intended use
The tool is intended for cutting tracks in concrete walls or
cutting in ferrous materials or concrete drainage chan-
nels with a diamond wheel but without using water.
Power supply
The tool should be connected only to a power supply of
the same voltage as indicated on the nameplate, and
can only be operated on single-phase AC supply. They
are double-insulated in accordance with European
Standard and can, therefore, also be used from sockets
without earth wire.
2
4112S
3,500
)
with household
equipment
to an environmentally
305 mm
100 mm
648 mm
10.3 kg
END201-2
For Model 4112S. 4112HS
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
sound pressure level: 103 dB (A)
sound power level: 116 dB (A)
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN50144.
waste
For Model 4114S
For European countries only
Noise and Vibration
The typical A-weighted noise levels are
and its
sound pressure level: 99 dB (A)
sound power level: 112dB (A)
– Wear ear protection. –
The typical weighted root mean square acceleration
value is not more than 2.5 m/s
These values have been obtained according to
EN50144.
EC-DECLARATION OF CONFORMITY
We declare under our sole responsibility that this product
is in compliance with the following standards of stand-
ardized documents, EN50144, EN55014, EN61000 in
accordance with Council Directives, 89/336/EEC, 98/37/
EC.
MAKITA INTERNATIONAL EUROPE LTD.
Michigan Drive, Tongwell, Milton Keynes, Bucks MK15
8JD, ENGLAND
Responsible manufacturer:
Makita Corporation Anjo Aichi Japan
4112HS
5,000
/II
2
.
2
.
Yasuhiko Kanzaki CE 2005
Director
4114S
355 mm
125 mm
3,500
675 mm
10.9 kg