Set Up For Pc Input Signals - Panasonic TU-PTA500U Operating Instructions Manual

SET UP for PC Input Signals

Press the MENU button to display the PC MENU screen, and select PC
MENU.
CH
ACTION
VOL
CH
MENU
SYNC
Setting PC sync signal setting:
Confirm that the input is set to PC INPUT (this setting is valid only for PC
INPUT).
H&V: The H and V sync signals are input from the HD / VD connector.
ON G: Uses a synchronized signal on the Video G signal, which is input
from the G connector.
PULL IN RANGE
Sets the width for different frequencies.
CLAMP POSITION
Adjusts the clamp position.
The following operation methods are the same for "SIGNAL" menu.
Normally, these adjustments are set to appropriate levels and therefore do
not need to be altered.
H-FREQ (kHz) / V-FREQ (Hz)
Displays the H (horizontal) / V ( vertical) frequencies.
Display range:
Horizontal 15.5 – 110 kHz
Vertical 48 – 120 Hz
52
Press to select each item.
Press to adjust.
VOL
Press to end.
SIGNAL
SYNC H & V
PULL-IN RANGE NARROW
CLAMP POSITION
H-FREQ. 31.5 kHz
V-FREQ. 60.0 Hz
CHANGE SELECT
EXIT
SYNC H & V
SYNC ON G
PULL-IN RANGE NARROW
PULL-IN RANGE WIDE
CLAMP POSITION
H-FREQ. 31.5 kHz
V-FREQ. 60.0 Hz