VIDEO IN
AUDIO IN
DC IN 4.5V
SENSOR
2
3
A
g
B
h
SL-MV65
14
TV
1
AV OUT
2
PBC OFF
NOR
RESUME
3
A
HOLD
NTSC
PAL
HOLD
R
SL-MV65
HOLD
h
i
HOLD
i
EQ
PLAY MODE ¥LIGHT/ / —DISP
Before Operating the Unit
1
Connect the unit to your TV to play
video CDs.
Use the Audio/Video cable (included).
a Yellow
d Black
2
Set video format selector according to
the television set.
NTSC: if your TV is NTSC
PAL: if your TV is PAL
For details, refer to the operating instructions of the TV.
3
Release the hold mode.
f
Front panel of the unit
Note
•
Video CD output is generally lower than TV output. Reduce
the TV volume before switching input back to TV.
•
Some TVs are unable to output sound when there is no
video signal.
To listen through the stereo earphones
(included)
•
SL-MV65
Connect the stereo earphones and wired remote control
(SL-MV65) to the (l) jack. (Plug in firmly.)
•
SL-MV60
Connect the stereo earphones to the (l) jack. (Plug in firmly.)
g Plug type: 3.5mm stereo
•
Before connecting the stereo earphones, reduce the
volume level.
•
When [AV OUT] is connected, you cannot listen through
stereo earphones or adjust earphone volume. "VOLpp"
will be displayed when [VOLUME, o, p] (unit) or [VOLo,
VOLp] (wired remote control) is pressed.
HOLD function
L
This function causes the unit to ignore short, accidental
button presses. (The disc lid can still be opened and closed.)
The HOLD function prevents the following:
•
Powering on the unit accidentally (which can cause the
batteries to run down).
•
Play being cut off unexpectedly in the middle of a selection.
To use the HOLD function
Set [HOLD] to the HOLD position. It is possible to operate
the unit from the wireless remote control in the HOLD mode.
h Release
i HOLD mode
SL-MV65
The unit and wired remote control have [HOLD] switches,
each of which works independently.
"
" indication
When the unit is in HOLD mode, pressing any button
causes the indication "
When the wired remote control is in HOLD mode, pressing
any button will not cause any effect.
When the unit is turned off
The "
" indication appears only when [:/J SELECT]
is pressed.
b White
c Red
e Rear panel of the unit
A
B
" to appear on the display.