Table Of Contents; Preface; Features; Precautions - Panasonic WV-CM2000 Operating Instruction

PREFACE .......................................................................... 1
FEATURES ........................................................................ 1
PRECAUTIONS ................................................................. 1
MAJOR OPERATING CONTROLS AND
THEIR FUNCTIONS ........................................................... 2
CABLE INFORMATIONS ................................................... 5

PREFACE

The Panasonic's Colour Monitor WV-CM2000 has a high
resolution S-VIDEO INPUT to ensure high definition picture
quality for a PAL/NTSC/M-NTSC (Modeified NTSC) signal.
All controls except for power and Input Signal Selection
Switch are covered by a push door to give a sleek appear-
ance on the front. The master controls for Tint, Colour,
Brightness and Contrast are provided with sub controls to
permit adjustment of preset levels.

FEATURES

• Approx. 54.8 cm (21" diagonal)
• Switchable of AFC time constant
• Looping through BNC connectors for video input and
output
• Looping through S-video connectors for S-video input
and output.
• Looping through RCA pin jack for audio input and out-
put

PRECAUTIONS

• Do not block the ventilation slots.
• Do place the video monitor at least 5cm (2") apart
from the wall.
• Do not expose the monitor to water or moisture.
• Do not operate the monitor if it becomes wet.
• Do take immediate action if ever the monitor does
become wet. Turn power off and refer service person-
nel. Moisture can damage the monitor and also cre-
ate the danger of electric shock.
• Do not drop metallic parts through slots. This action
could permanently damage the monitor.
power off immediately and refer servicing to qualified
service personnel.
• Do not attempt to disassemble the monitor. To pre-
vent electric shock, do not remove screws or cover.
There are no user serviceable parts inside. Refer ser-
vicing to qualified service personnel.
CONTENTS
SYSTEM CONNECTIONS .................................................. 6
APPEARANCE ................................................................... 7
SPECIFICATIONS .............................................................. 8
Standard BNC and S-Video input and output connectors
enabled WV-CM2000 to be used with other CCTV monitors
or Panasonic video tape recorder.
• PAL/NTSC/M-NTSC selectable
• 3.58 MHz Trap On/Off Switch for NTSC
• Stand-by On/Off Switch is provided for energy saving
• Picture Selection Switch is provided.
• Max. 1.3W for speaker output
• Selectable of 1-4 channel for input and output signal.
• Do not use the monitor beyond its temperature,
humidity or power source ratings.
(a) Ambient temperature must not range beyond 10°C -
+50°C.
(b) Avoid using the monitor when humidity is above 90%.
(c) The input power must be 220-240 VAC at 50Hz.
Do turn
-1-