Table of Contents
Advertisement
To view the contents of the Frame Sequential format (ex. 3D-compatible Blu-ray Disc, etc.) with
3D effect
Connect the 3D-compatible player via an HDMI cable (p. 11 and p. 92) and playback the contents.
●
Use fully wired HDMI compliant cable.
●
For the settings of the player, read the manual of the player.
●
If input mode is not switched automatically, select the input mode connected to the player (p. 24).
●
If you use the non 3D-compatible player, the images will be displayed without 3D effect.
To view the contents or programmes of "Side by Side" or "Top and Bottom" with 3D effect
Select suitable picture format in "3D Picture Format" (p. 31) before viewing.
●
You can view the contents with 3D effect even if you use the non 3D-compatible player.
●
Please consult the suppliers of contents or programmes for availability of this service.
●
You can also view 3D programmes recorded to the registered USB HDD with 3D effect by Media Player (p. 62
and p. 71).
Turn the 3D Eyewear on
●
Press the power button on the 3D Eyewear for about 1 second. (p. 27)
Supporting the 3D Eyewear
●
If the 3D Eyewear slips out of place, hold it in place using the support band, and adjust the length of the band.
(p. 28)
View the 3D images
●
Safety precautions will be displayed on the first 3D image
detection. Select "Yes" or "No" to continue to view 3D images.
If you select "Yes", this message will be displayed again
in the same condition after Mains power On / Off switch is
next turned On. Select "No" if you do not wish to display this
message again.
■
To turn the 3D Eyewear off
After using the 3D Eyewear, press the power button on the 3D Eyewear for about 1 second to turn it off. (p. 27)
Note
●
The 3D image or 3D effect may not be available while multi window (p. 58) is active, VIERA CAST home screen
(p. 83) is displayed or Ext Rec. of Timer Programming (p. 50) / Direct TV Recording (p. 86 and p. 88) is in
progress. As for the contents of the Frame Sequential format, no images will be displayed in these conditions.
●
If the room is lit by using fluorescent lights / dimmers (50 Hz) and light appears to flicker when using the 3D
Eyewear, switch off or dim the light.
●
Liquid crystal displays (such as computer screens, digital clocks or calculators, etc.) may be difficult to see while
wearing the 3D Eyewear.
If the 3D Eyewear is placed outside the coverage area for about 5 minutes, the 3D Eyewear will be
turned off automatically.
: Coverage area for using the 3D Eyewear
35°
View from the top
Note
●
You cannot view the 3D images with the 3D Eyewear too far from the TV, because of the difficulty of receiving
infrared signals from the TV.
●
The range may be shortened depending on the obstacles between the infrared sensors on the TV and the 3D
Eyewear, the dirt on the infrared sensors or the surrounding environment.
●
If you do not look toward the TV screen for a while when viewing 3D images, the 3D Eyewear may be turned off
automatically even if in the coverage area.
To view the 3D images
Coverage area / range for 3D viewing
35°
Example:
Safety Precautions
To enjoy 3D images safely and comfortably, please read the Operating Instructions fully.
Please stop using the 3D Eyewear immediately, if you feel tired, are not feeling well or
experience any other uncomfortable sensation.
Always put the 3D Eyewear in the case provided after use.
Would you like to display this message again later?
Yes
20°
20°
View from the side
No
29
Advertisement
Table of Contents
