Panasonic WV-CF250 Operating Instructions Manual page 19

4. Repeat step 3 to mask the desired areas. To
cancel masking, move the cursor to that area
and press (S).
Turns to white
Blinking
5. After masking is completed, press
seconds or longer. The ALC CONT menu
appears.
6. If you want to change the video output level
(picture contrast), move the "I" cursor to
LEVEL and adjust the level.
7. Move the cursor to RET and press
return to the CAM SET UP menu. (To return to
the camera picture, move the cursor to END
and press (S).)
3. Shutter Speed Setting (SHUTTER)
Note: When ON is selected for SUPER-D on the
ALC CONT menu, this item is not available.
To select electronic shutter speed, select OFF
for SUPER-D in the menu.
You can select an electronic shutter speed of 1/50
(OFF), 1/120, 1/250, 1/500, 1/1 000, 1/2 000, 1/4 000,
or 1/10 000 seconds.
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SYNC
WHITE BAL
END SET UP ENABLE
Move the cursor to the SHUTTER parameter and
select the electronic shutter speed.
The preset values for SHUTTER (electronic shutter
speed) change by pressing
follows:
OFF (1/50) 1/120
1/10000 1/4000
(S) for 2
(S) to
OFF
ALC
---
ON
INT
ATW
(L) or (R) as
1/250 1/500
1/2000 1/1000
4. Gain Control Setting (AGC ON/OFF)
You can set the gain (brightness level portion of an
image) to automatic level adjustment (ON) or fixed
level (OFF).
CAMERA ID
ALC/ELC
SHUTTER
AGC
SYNC
WHITE BAL
END
Move the cursor to the AGC parameter and select
automatic level adjustment (ON) or fixed level
(OFF).
5. Synchronization Setting (SYNC)
You can select internal sync mode (INT) or line-lock
mode (LL). The VD2 signal (multiplexed vertical
drive signal) with the composite video output signal
from external equipment such as a Matrix Switcher
is also acceptable.
Whenever the VD2 signal is supplied to this cam-
era, the camera automatically switches to the VD2
sync mode.
1. Move the cursor to the SYNC parameter and
select line-lock (LL) or internal (INT).
2. Press (S).
If LL is selected, the SYNC menu appears. (If
INT is selected, the synchronization mode is
automatically set to internal sync pulse, and
the menu is not displayed.)
** CAM SET UP **
CAMERA ID
ALC/ELC
SHUTTER
AGC
SYNC
WHITE BAL
END
Important Notices:
1. The priority for the sync modes is as follows.
1. Multiplexed Vertical Drive (VD2) (Highest
priority)
2. Line-lock (LL)
3. Internal Sync (INT) (Lowest priority)
2. The line-lock mode has its own menu for line-
lock vertical phase adjustment. If the camera
installation is relocated, check the vertical
phase adjustment again since the AC line
phase may be different.
-17-
** CAM SET UP **
OFF
ALC
---
ON
INT
ATW
SET UP ENABLE
OFF
ALC
---
ON
INT
ATW
SET UP ENABLE