Install The Pop-Up Drain - Grohe Axor 17010XX1 Installation Instructions Manual

Install the pop-up drain

Remove the plunger assembly.
Unscrew the drain outlet flange from the tee.
plunger
Unscrew the tailpiece from the tee. Wrap
height adjuster
the threads with two layers of Teflon tape
and replace.
flange
Install the white, flexible sealing gasket to the
flange. Place it in the sink outlet.
From under the sink, install the black mack
gasket, white friction ring and retainer nut
sealing gasket
to the flange. Do not tighten the nut against
the bottom of the sink at this time.
mack gasket
Thread the tee and tailpiece to the flange.
The pivot must face the faucet. If necessary,
turn the drain assembly.
vertical rod
friction ring
Tighten the retainer nut.
retainer nut
Place the plunger assembly in the drain.
Install the horizontal rod so that the end goes
tee
through the loop in the bottom of the height
adjuster.
pivot ball nut
Install and hand tighten the pivot ball nut.
Attach the swivel connector to the end of the
tailpiece
horizontal rod.
horizontal rod
Attach the swivel connector to the end of the
vertical rod. Position as desired and tighten
with a small, flathead screwdriver.
swivel connector
4