Connect The Handspray Hose; Connect The Supplies; Install The Hose Weight - Grohe 35807801 Installation Instructions Manual

Connect the handspray hose:

Loosen the compression fitting on the end of the flexible
handspray hose. Slide it onto the end of the handspray
supply hose.
While holding the hose still with a 1 mm wrench, tighten the
nut with a 17 mm wrench.
Do noT aLLoW THe HoSe To TWIST. IF THe HoSe
TWISTS, THe FLoW FRoM THe SPRayHeaD May Be
ReDuceD.

Connect the supplies:

connect the hot and cold supply hoses to the
supplies with 3/8" compression fittings (not
included). Tighten them wrench tight.
use two wrenches, as shown in the diagram. Do
not allow the hot and cold supply hoses to twist.

Install the hose weight:

Proper installation of the hose weight will insure that the handspray hose retracts smoothly.
on the handshower side of the hose, use a ruler to measure 15" down from the body of the
faucet. Install the hose weight at this point.
Pull out on the handspray and guide it back into the faucet. It should move easily and
retract smoothly. Reposition the hose weight if necessary.
Turn on the water. Check all connections for leaks. Check the faucet for
proper operation.
4