Using The Telephone; Battery Charging; Replacing The Batteries; Before Initial Use - Panasonic KX-TCD755E Operating Instructions Manual

Battery Charging

(Before Initial Use)

! The batteries must be charged
for approximately 15 hours
before initial use.
After the batteries have been inserted
into the handset, place the handset in
the powered up base unit.
(The telephone line cord must not
be connected to the telephone
socket at this time. Please leave
your standard telephone
connected until battery charging
is complete).
The batteries are fully charged only
when Ò Ò is flashing.
(After Initial Use)
When the battery icon flashes (and, if
programmed, battery low alarm
sounds), the handset should be
charged immediately because there is
little energy left in the batteries.

Battery Life

Battery life is dependent on use and
conditions but in general when using
fully charged Ni-MH batteries:
Talk time: 20hrs approx.
Talk time (Walkie-Talkie mode):
12hrs approx.
Standby time: 200hrs approx.
(Times indicated are for peak
performance).
The batteries reach peak performance
after several full charges.
The batteries cannot be overcharged
unless they are repeatedly removed
and replaced.
If battery life is shortened then
please check that battery and charge
terminals are clean.
For maximum battery life it is
recommended that the handset is not
recharged until battery icon flashes
(Û Û ).
Helpline Tel.No. : U.K. 08700 100 076

Replacing the batteries

If the Û Û icon flashes after a few
telephone calls even when the
handset batteries have been fully
charged, the batteries must be
replaced.
! Charge new batteries for
approximately 15 hours before
initial use.
(The telephone line cord must not
be connected to the telephone
socket at this time).
Power the handset off before
removing the old batteries.
If the batteries are removed, the
battery icon is reset to Û
30% capacity). In this case, even if
fully charged batteries are fitted, the
icon remains as Û Û until a full
charge cycle is complete.
Please use only Panasonic AA(R6)
P-6P (Ni-MH) batteries.
Turning the Power ON/OFF
Turn Power ON
Z and hold P P until a
Z
confirmation tone sounds.
When the button is released, the
display changes to the standby mode.
Turn Power OFF
From the standby mode, Z
hold P P until a long tone sounds.
The display goes blank. If you put the
handset in the base unit, the battery
icon will display.
R.O.I. 01289 8333
Û (less than
Z and
5