Useful Information - Panasonic KX-TCD150F Operating Instructions Manual

TCD150FX(e-e).book Page 15 Thursday, June 9, 2005 6:59 PM

Useful Information

Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the AC
adaptor and turn off the handset, then reconnect the AC adaptor and turn on the handset.
Problem
w is flashing.
I cannot make or receive calls.
The unit does not ring.
Cause & solution
L The handset is too far from the base unit. Move
closer.
L The AC adaptor is not connected. Check the
connections.
L You are using the handset or base unit in an area
with high electrical interference. Locate the
handset and base unit away from interference
sources, such as antenna and mobile phones.
L The handset registration is cancelled. Register the
handset to the base unit using the following
method.
1
{j/OK}
2
"SETTING HS" i {>}
3
"REGISTRATION" i {>}
4
"REGISTER HS" i {>}
5
Press and hold {x} on the base unit until the
registration tone sounds.
L The rest of the procedure must be completed
within 1 minute.
6
Select a base unit number ({v}). i {>}
7
Wait until "BS PIN" is displayed. i Enter
base unit PIN (default: "0000"). i {>}
L A confirmation tone will sound, and w will
stop flashing.
L The AC adaptor or telephone line cord is not
connected. Check the connections.
L The call bar feature is turned on. Turn it off (page
10).
L You dialled a call restricted number (page 13).
L The key lock feature is turned on. Turn it off (page
8).
L The dialling mode setting is incorrect. Set to
"Tone" or "Pulse" as needed (page 7).
L The ringer volume is turned off. Adjust the ringer
volume (page 10, 12).
Useful Information
15