Confirming The Preset Channels - Panasonic SC-PTX50 Operating Instructions Manual

4
step
Preparing the remote control
∫ Batteries
Insert so the poles (i and j) match those in the remote control.
R6/LR6, AA
Replace the cover.
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type recommended by the manufacturer.
Dispose of used batteries according to the manufacturer's instructions.
≥ Do not use rechargeable type batteries.
≥ Do not heat or expose to flame.
≥ Do not leave the battery(ies) in an automobile exposed to direct
sunlight for a long period of time with doors and windows closed.
5
step
Presetting the radio stations
FM
Numbered
buttons
,
Radio operations are described mainly with the remote control.
You can alternatively use the corresponding button on the main unit.
§1 §2
[SELECTOR]
8
Press in and lift up.
,
ENTER
MANUAL SKIP
MEMORY
SELECTOR
TUNING
-TUNE MODE
[X TUNING W]
§3
[MEMORY]
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage which can
severely damage the remote control.
Remove the batteries if the remote control is not going to be used for a
long period of time. Store in a cool, dark place.
∫ Use
Aim at the remote control signal sensor (➜ page 11), avoiding
obstacles, at a maximum range of 7 m directly in front of the unit.
Up to 30 stations can be set.
1 §1
Press [FM] to select "FM".
2 Press [6, 5] §2
to select the frequency.
≥ When performing this step on the main unit, first press
[-TUNE MODE] to select "MANUAL", and then press
[X TUNING W] to select the frequency.
To start automatic tuning, press and hold [6, 5] until the
frequency starts scrolling. Tuning stops when a station is found.
3
While listening to the broadcast
§3
Press [ENTER] .
4
While the frequency and "PGM" are flashing on the display
Press the numbered buttons to select a channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W], and then
§3
press [ENTER] .

Confirming the preset channels

1
§1
Press [FM] to select "FM".
2
Press the numbered buttons to select the channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W].
≥ To perform this step on the main
unit, first press [-TUNE MODE] to select "PRESET", and then
press [X TUNING W] to select the channel.
DISC SFC TG D.MIX MONO SLP
PRG DISC SFC TG D.MIX MONO SLP
DE
S
A AC