Confirming The Preset Channels - Panasonic SC-PTX5 Operation Manual

step 3
Preparing the remote control
∫ Batteries
Insert so the poles (i and j) match those in the
remote control.
R6/LR6, AA
Replace the cover.
≥ Do not use rechargeable type batteries.
4
step
Presetting the radio stations
FM
Numbered
buttons
,
Radio operations are described mainly with the remote
control.
You can alternatively use the corresponding button on
this unit.
§1 §2
[SELECTOR]
8
Press in and lift up.
,
ENTER
MANUAL SKIP
SELECTOR MEMORY
TUNING
-TUNE MODE
[X TUNING W]
§3
[MEMORY]
Do not:
≥ mix old and new batteries.
≥ use different types at the same time.
≥ heat or expose to flame.
≥ take apart or short circuit.
≥ attempt to recharge alkaline or manganese batteries.
≥ use batteries if the covering has been peeled off.
Mishandling of batteries can cause electrolyte leakage
which can severely damage the remote control.
Remove the batteries if the remote control is not going
to be used for a long period of time. Store in a cool, dark
place.
∫ Use
Aim at the remote control signal sensor (➜ page 11),
avoiding obstacles, at a maximum range of 7 m
directly in front of the unit.
Up to 30 stations can be set.
1 §1
Press [FM] to select "FM".
2 Press [6, 5] §2
to select the frequency.
≥ When performing this step on this unit, first press
[-TUNE MODE] to select "MANUAL", and then
press [X TUNING W] to select the frequency.
To start automatic tuning, press and hold
[6, 5] until the frequency starts scrolling.
Tuning stops when a station is found.
3
While listening to the broadcast
§3
Press [ENTER] .
4
While the frequency and "PGM" are flashing on the
display
Press the numbered buttons to select a channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W], and
then press [ENTER] §3

Confirming the preset channels

1 §1
Press [FM] to select "FM".
2
Press the numbered buttons to select the
channel.
≥ To select a 2-digit number
e.g. 12: [S10] ➜ [1] ➜ [2]
Alternatively, press [X, W].
≥ To perform this step on this
unit, first press [-TUNE MODE] to select
"PRESET", and then press [X TUNING W] to
select the channel.
e.g. Display
DISC SFC TG D.MIX MONO SLP
.
e.g. Display
DISC SFC TG D.MIX MONO SLP