Download Print this page

Kenwood SJ330 series User Manual

Hide thumbs

Advertisement

Quick Links

G
safety
This kettle is for domestic use only.
G
Failure to observe these cautions
G
Always use the filter and never
may result in damage to the kettle.
overfill - boiling water may splash
before plugging in
out.
G
Make sure your electricity supply is
G
Avoid contact with steam coming
the same as the one shown on the
out of the spout area when
underside of your kettle.
pouring and out of the lid when
Important – UK only
refilling.
G
The wires in the cord are coloured
G
Beware: the metal body of the
as follows:
kettle will get hot during operation.
Green and Yellow = Earth,
G
Keep small children away from the
Blue = Neutral,
kettle and never let the cord hang
Brown = Live.
down over the worktop edge - a
G
The appliance must be protected
child could grab it and pull the
by a 13A approved (BS1362) fuse.
kettle down.
G
WARNING: THIS APPLIANCE
G
If you do not need so much cord,
MUST BE EARTHED.
shorten it by wrapping any excess
cord around the bracket on the
Note:
underside of the powerbase.
G
For non-rewireable plugs the fuse
G
Always unplug your kettle
cover MUST be refitted when
when not in use.
replacing the fuse. If the fuse cover
G
Never put the kettle, powerbase,
is lost then the plug must not be
cord or plug in liquid.
used until a replacement can be
G
Do not use if there is any damage
obtained. The correct fuse cover is
to the kettle, powerbase, cord or
identified by colour and a
plug. Get it checked or repaired:
replacement may be obtained from
see 'service'.
your Kenwood Authorised Repairer
G
This kettle is not intended for use
(see Service).
by young children or infirm persons
G
If a non-rewireable plug is cut off it
without supervision.
must be DESTROYED
G
Young children should be
IMMEDIATELY. An electric shock
supervised to ensure they do not
hazard may arise if an unwanted
play with the appliance.
non-rewireable pug is inadvertently
G
Caution: Do not operate the
inserted into a 13A socket outlet.
kettle on an inclined surface.
G
This kettle complies with European
G
Only use the powerbase supplied
Economic Community Directive
and keep it clean and dry.
89/336/EEC.
G
Make sure the lid is secure before
before using for the first
switching the kettle on.
G
Warning: Do not remove the lid
time
G
while the water is boiling.
Remove all packaging and any
G
labels.
Make sure the kettle is switched
G
off before lifting or pouring.
Fill to 'MAX', boil, then pour the
G
Remove the kettle from the base
water away. Repeat 2 to 3 times.
before filling or pouring.
G
Never put the kettle near or on
cooker hot plates or gas burners.
G
This kettle is for boiling water only.
know your Kenwood
boil-dry protection
G
For safety your kettle is fitted with
stainless steel jug kettle
a re-setable thermal fuse. If you
switch on with too little water, your
spout
kettle will cut out automatically.
lid
Switch off and let it cool down
water gauge
before re-filling. When it has
on/off switch with neon
cooled down, the switch will reset
360˚ powerbase
itself.
cord storage
scale filter

care and cleaning

to use your stainless
Before cleaning, unplug your kettle
steel jug kettle
and let it cool down.
the outside and powerbase
1 Fill it though the spout or lid. The
G
Wipe with a damp cloth, then dry.
water level must be between 'Max'
Do not use abrasives - they will
and 200ml (1 cup).
scratch the metal and plastic
G
Always use the filter and never
surfaces.
overfill - boiling water may splash
out.
the inside
G
G
Be economical: do not boil more
Wipe with bicarbonate of soda on
water than you need.
a damp cloth. Rinse thoroughly.
G
To improve the quality of your
G
Even though your kettle comes
drinks always use fresh water.
with a scale filter, you still need to
G
Empty the kettle after each use.
clean the inside (and the filter)
2 Check the lid is closed.
regularly.
3 Plug in and switch on. The neon
the scale filter
will come on.
1 Open the lid.
4 Your kettle will boil and switch off
2 Remove the scale filter by
automatically. To re-boil, wait a
holding the tab and then lifting the
few seconds - the on/off switch
filter out.
needs time to reset.
3 either rinse under the tap or use
G
If you experience problems
a soft brush
with your kettle switching
or when descaling your kettle,
on and off during use or
drop the filter in too. Rinse
switching off before boiling,
thoroughly.
check that the flat element
4 To re-fit the filter, hold the tab
is free from scale - see
Then slide the filter down into the
"descaling". If descaling
bracket until secure
does not solve the problem
contact Kenwood customer
care.
G
Your kettle is fitted with a scale
filter to hold back limescale
particles.
G
If you find drops of water under
your kettle, don't worry - it is just
condensation.
.
.

Advertisement

loading

  Also See for Kenwood SJ330 series

  Summary of Contents for Kenwood SJ330 series

  • Page 1: Care And Cleaning

    3 Plug in and switch on. The neon replacement may be obtained from the scale filter see ‘service’. will come on. your Kenwood Authorised Repairer 1 Open the lid. This kettle is not intended for use 4 Your kettle will boil and switch off (see Service).
  • Page 2 92392333 and ask for customer incorrectly; and care. you supply your receipt to show when you bought it. This guarantee does not affect your statutory rights. SJ330 series Kenwood Limited, New Lane, Havant, Hampshire PO9 2NH, UK SJ340 series www.kenwood.co.uk 54600/2...

This manual is also suitable for:

Sj340 series